Search results

Check the casting numbers on the case and count the splines. This will tell you if its a Muncie or not. https://www.5speeds.com/muncie2.htm

That's why I keep the old OTC 4000e around even though I keep tripping over it.

Keeping the 228ci would be dependent on what can be re-used and what needs to be replaced. Obviously the block but what else is needed to end up with a running engine? IIRC, the 228ci has parts that are unique to that engine. Found this on another site...

If you're looking for coolant for your 2022 Hyundai, I believe the factory fill is blue. I don't think coolant color means much. It's better to match the chemistry of the factory and aftermarket coolant to ensure compatibility. Or just buy the correct coolant from the dealer parts department.

Do you have your owner's manual for the car? Review Page 80 and see if the doors behave as described. It may help diagnose what's going on. What sticks out like a sore thumb is "....aftermarket remote start fob...." Did you program the fob or was it provided when you took possession of the...

Fuel pressure specification is 44 psi - 50 psi.

Attachements from TIS. No tightening pattern for the cover. Start at the center of the cover and criss-cross.

You might try to find a Generac distributor. Less the sales pitch, they should be a bit more responsive since they should be a bit more local.

This should answer your VB questions. Hopefully, you have something similar to guide you. There might be some transmission model specific differences so be sure of what you're working with. I just linked the first ATSG manual I came across at that site. The site might have others so do a...

I think he's looking for a Pulsajet carb. I haven't seen those since my mini-bike days. I ran B&S engines with Flojet carbs. Mechanical Governor...

Sorry. I thought you were referring to those cheap solar panels with alligator clips.

After you get it sorted, get a battery maintainer (shop around for the best price): https://www.batterymart.com/p-batteryminder-1510-12-volt-1_5-amp-charger.html This maintainer will work plugged into an extension cord as well. It comes with a 2-wire trailer type pigtail so it's convenient to...

Water and engine oil make a decent lube but it's a bit light in viscosity. :rolleyes: Years ago when I was working at a paving equipment dealership, we had an old Yale fork lift that had a flat head four in it. Head gasket leaked so much water in to the crankcase, we'd have to add water every...

I recently pitched my factory Toyota '87 Camry service manual. Unfortunate circumstance. Again as I recollect, the junction box is either on the underside of the trunk lid (behind the lights) or on the back wall of the trunk (behind the lights). It's maybe a 2" or 3" square box. I think the...

You don't mean an FH641V? Maybe this might help: https://www.manualslib.com/products/Kawasaki-Fh641v-2609113.html

My '03 Safari has a similar system (CSFI) that's sequential instead of "fire all at once" like the one you have. The CxFI systems are known for leaking. I would see if a leak-down test shows anything. Connect the fuel pressure gauge. Do a few key-on-engine-off cycles to get max pressure and...

When you were tearing down the transmission, where (visually) was the evidence of the slipping?

FWIW... I had an '87 Camry years ago. It also had a brake light problem. IIRC, no brake lights and no brake lamp failure warning light. There is a plastic junction box/block inside the trunk (either on the back wall of the trunk or lid) where I found a loose ring terminal under a screw...

Maybe this is it?